Delta 22-785 Manual de Instruções

INSTRUCTION MANUAL15" Planer(Model 22-785)(Model 22-785X)PART NO. 909593 - 06-07-05Copyright © 2005 Delta MachineryTo learn more about DELTA MACH

10ASSEMBLING TOP COVER ANDDUST CHUTE1. Fasten the top cover and dust chute (A) Fig. 16, tothe top of the planer, as shown, using the threeM6x16mm scre

11DEPTH OF CUT ADJUSTMENTThe depth of cut on your planer is controlled by raisingor lowering the head assembly (A) Fig. 22, whichcontains the cutterhe

12ANTI-KICKBACK FINGERSWHEN INSPECTING AND CLEANINGTHE ANTI-KICKBACK FINGERS, MAKESURE THE MACHINE IS DISCONNECTED FROM THEPOWER SOURCE.A series of an

13Fig. 324. Remove the three screws (E) Fig. 34, and remove thechip deflector (F).5. To check and adjust the knives, proceed as follows:A. Carefully p

14CONSTRUCTINGGAGE BLOCKIn order to check and adjust the height of thechipbreaker, infeed and outfeed roll and adjust thecutterhead parallel to the ta

15ADJUSTING HEIGHTOF INFEED ROLLERThe infeed roller is adjusted at the factory at 0.040"below the cutting circle. To check and adjust theheight o

16ADJUSTING SPRING TENSION OFINFEED AND OUTFEED ROLLERSThe infeed and outfeed rollers are those parts of yourplaner that feed the stock while it is be

17ADJUSTING CUTTINGHEADPARALLEL TO TABLEThe cuttinghead is set parallel to the table at the factoryand no further adjustment should be necessary. If y

MAINTENANCEFig. 53 Fig. 54ABFig. 55ECDFig. 56FLUBRICATIONThe gear box oil should be changed once a year. Useextreme pressure gear oil, available from

19KEEP MACHINE CLEANPeriodically blow out all air passages with dry compressedair. All plastic parts should be cleaned with a soft dampcloth. NEVER us

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.ADDITIONAL SPECIFIC SAFETY RULESSAVE THESE INSTRUCTIONS. Refer to them often and

6Fig. AGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESPOWER CONNECTIONSMOTOR SPECIFICATIONSGROUNDING INSTRUCTIONS3.

7FOREWORDDelta Models 22-785 and 22-785X are 15" (381mm) Planers with adjustable feed rate for optimum planing under load.They have the following

81 - Top cover2 - Cord clamp3 - Knife setting gage4 - Open end wrench (14 and 17mm)5 - Open end wrench (10 and 12mm)6 - M6x1x16mm hex flange screw (4)

9CUTTINGHEAD RAISING ANDLOWERING HANDWHEEL1. Insert key (A) Fig. 7, into keyway (B) of raising andlowering shaft.Fig. 7Fig. 82. Assemble handwheel (C)