Delta 36-953 Manual de Instruções descarregar pdf (Página 14)

Fig. 22

Fig. 23

Fig. 25

Fig. 24

Fig. 26 Fig. 27

5/16" lockwasher, then a 5/16" flat washer, onto a 5/16-

18x1" hex head screw (N), insert the screw (N) through

the hole in the upper splitter bracket (M) and thread the

screw into the lower splitter bracket (L). NOTE: Do not

tighten screw (N) at this time.

9. Insert the front end of splitter (P) Fig. 23, inside the

splitter mounting bracket behind splitter fastener plate

and screw (C). Push splitter down as far as possible,

making certain the bottom edge of splitter (P) is parallel

with the table surface. Tighten screw (C). Fasten splitter

and blade guard assembly (P) Fig. 24, to bracket (M)

using a 5/16-18x1" hex head screw (V) and 5/16" flat

washer (O).

10. IMPORTANT: The splitter (P) Fig. 25, features a notch

(W) cut into the top edge. Raise the front of the clear

blade guard (G) Fig. 25, until the rear edge of the guard

slips into notch (W) of the splitter. This notch enables the

blade guard to stay in the raised position and makes

changing blades easier.

11. Reassemble the saw blade, making certain the teeth

are pointing down at the front of the saw table as shown

in Fig. 26, and assemble the outside blade flange and

arbor nut (X). With open end wrench (Y) on the flats of the

arbor to keep it from turning, tighten arbor nut by turning

box end wrench (Z) clockwise.

12. Using a straight edge (A) Fig. 27, make certain the

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sem comentários

Delta 36-953 Manual de Instruções Página 14