Delta MS250 Manual do Operador descarregar pdf (Página 6)

Operator's Manual

Safety

Observe these instructions to keep the product operating in a correct and safe condition.

You are required to follow generally accepted safety procedures in addition to the

precautions specified in this section. The overall safety of any system incorporating this

product is the responsibility of the assembler of the system.

Symbols

These symbols appear on the product or in its documentation to alert you to important

safety considerations.

CAUTION of potential damage to product, or WARNING of potential bodily

injury. Attend to the accompanying information to protect against injury or

damage. Do not proceed until conditions are fully understood and met.

ELECTROSTATIC DISCHARGE (ESD) HAZARD. Susceptible to damage if anti-

static measures are not taken.

DOUBLE INSULATION

GROUND

Precautions

Use only as intended. The product is intended to be used only with the compatible

Teledyne LeCroy instruments. Use of the product and/or the equipment it is connected to

in a manner other than specified may impair the protection mechanisms.

Do not apply a voltage to any input that exceeds the maximum rating of that input. Refer to

the body of the oscilloscope and the product page at teledynelecroy.com for detailed

information.

Comply with voltage derating curve. When measuring higher frequency signals, comply

with the Voltage vs. Frequency Derating Curve shown in this manual.

Connect and disconnect properly. Avoid damage through excessive bending of cables and

other equipment.

Use indoors only. The accessory is intended for indoor use and should be operated in a

clean, dry, environment.Do not use in wet/damp or explosive atmospheres.

Keep product surfaces clean and dry. See Cleaning for instructions.

Do not operate with suspected failures. Do not use the product if any part is damaged. All

maintenance should be referred to qualified service personnel.

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Sem comentários

Delta MS250 Manual do Operador Página 6