Delta RS830 Manual de Instruções descarregar pdf (Página 13)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

LEGS TO SAW BASE

1. Loosen lock knob (A) Fig. 8, and move cutting-head

(B) to the rear position as shown. Then tighten knob (A).

2. MAKE CERTAIN THE CUTTING-HEAD

IS CLAMPED SECURELY AT THE BACK OF THE

TRACK ARM.

Fig. 8

3. Place Radial Arm Saw on its back and assemble legs

corner of saw base (D) using sixteen 5/16-18 x 5/8"

carriage head screws, 5/16" flat washers, 5/16" external

tooth lockwashers, and 5/16-18 hex nuts. Place flat

washer on bolt. Insert bolt through holes then assemble

lockwasher and nut. Hand tighten, hardware at this time

but do not completely tighten.

4. Stand the saw in the upright position and securely

tighten all stand hardware.

Fig. 9

WRENCH HOOK TO SAW BASE

Assemble wrench hook (K) Fig. 10, to the front right

(as shown), or back left, side of saw base (D), using two

#10 x 1/2" sheet metal screws.

Fig. 10

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 2-3 hours.

7/8" Open End - 1/2" Box Wrench (included)

7/8" x 1/2" Box Wrench (included)

1/2” and 3/8” Wrenches, Open End or Socket

Flathead Screwdriver

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Sem comentários

Delta RS830 Manual de Instruções Página 13