Delta ShopMaster SM500 Manual do Utilizador descarregar pdf (Página 11)

1. Clean the sanding disc plate (A) Fig. 8.

2. Peel the backing from sanding disc and press the

disc (B) firmly into position all the way around the

sanding plate (Fig. 8).

Install the lower cover (A) Fig. 9 on the belt and pulley

guard, using the three M4 x .7 x 12mm sheet metal

screws (B).

1. Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 10 partially into the hole in the base of the sander.

Insert the rod (B) into the hole. Align the flat of the rod (B) with the screw (A). Tighten the screw (A).

2. Slide the table assembly (C) Fig. 11 on the rod (B).

3. Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 11 into the hole in the table support bracket. Align the

flat on the rod (B) with the screw (A). Tighten the screw (A).

To avoid trapping the work or fingers between the table and the sanding disc, the table edge (E)

Fig. 11 should be positioned a maximum of 1/16" away from the sanding disc (F). Loosen the

screw (A) and adjust the table accordingly.

ATTACHING THE SANDING DISC

Fig. 8

ATTACHING THE LOWER COVER FOR THE SANDING DISC

INSTALLING THE DISC SANDER TABLE

Fig. 9

Fig. 10

Fig. 11

A B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Sem comentários

Delta ShopMaster SM500 Manual do Utilizador Página 11