Delta 36-R53 Manual de Instruções descarregar pdf (Página 14)

2. Place the motor cover (A) in the opening of the

Unisaw as shown in Fig. 34. Place the rear motor cover

clips inside the motor opening and push the front of the

motor cover until all four motor cover clips are engaged

with the motor cover opening in the Unisaw.

3. Align the hole (B) Fig. 35 in the bottom of the motor

cover with the hole in the side of the saw cabinet. Place

a 1/4" flat washer on a 1/4-20x5/8" hex head screw.

Insert screw through hole in motor cover and thread

screw into hole in side of motor cabinet and tighten

securely.

4. Fig. 35 shows the motor cover attached to the

Unisaw.

NOTE: TO REMOVE THE MOTOR COVER, REMOVE

THE 1/4-20x5/8" HEX HEAD SCREW (B) FIG. 35, AND

PUSH MOTOR COVER TO ONE SIDE TO DEPRESS

CLIPS, AND PULL MOTOR COVER OFF.

Fig. 34

Fig. 35

RIP FENCE

HOLDER BRACKETS

Assemble the rip fence holder brackets (A) and (B) Fig.

36, to the four holes located in the left hand side of the

saw cabinet using four #10 x 1/2" sheet metal screws

supplied.

Fig. 36

DUST CHUTE ADAPTER

The Unisaw is supplied with a dust chute connector to

provide a means of connecting a 4" diameter dust

collector hose to the machine. Align the four holes in the

dust chute adapter (A) Fig. 37,with the four holes in the

back of the saw cabinet (B) and attach the dust chute

adapter with four #10 x 1/2" sheet metal screws.

DO NOT MOUNT THE DUST CHUTE

ADAPTER UNLESS A DUST COLLECTION SYSTEM

IS USED IN CONJUNCTION WITH THE SAW, FOR

THE DUST CHUTE ADAPTER WILL RESTRICT THE

GRAVITY FEED OPENING FOR SAW DUST

REMOVAL.

Fig. 37

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sem comentários

Delta 36-R53 Manual de Instruções Página 14