Delta MS350 Manual de Instruções

10" CompoundPower Miter Saw(Model MS350)INSTRUCTION MANUALPART NO. 906068 - 05-30-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 21To learn mo

10Fig. 20TILTING CUTTINGHEAD FORBEVEL CUTTINGThe cuttinghead of your compound miter saw can be tilted tocut any bevel angle from a 90 degree straight

ADJUSTING DOWNWARD TRAVEL OF SAW BLADE1. DISCONNECT MACHINE FROM POWER SOURCE.2. The downward travel of the saw blade should be limited to prevent the

124. If an adjustment is necessary, push in lock handle(D) Fig 24, and turn counter-clockwise. Loosen lockknob(B) Fig. 24, and use a 3mm hex wrench to

13TYPICAL OPERATIONS AND HELPFUL HINTSFig. 28A1. Before cutting, make certain the cuttinghead andtable are at their correct settings and firmly locked

14Fig. 30CFig.30BFig. 30DFig. 30A1. Your machine has the capacity to cut standard 2 x 4’s lying flat or on edge, at the 45 degree right and left miter

15Fig. 31Fig. 32CUTTING ALUMINUMAluminum extrusions such as used for making aluminumscreens and storm windows can easily be cut withyour compound mite

16Fig. 35Fig. 36Fig. 37Fig. 38CUTTINGCROWN MOULDINGOne of the many features of your saw is the ease ofcutting crown moulding.The following is an examp

17Fig. 41Fig. 42MAINTENANCECHANGING THE BLADEWARNING: USE ONLY CROSS-CUTTING SAWBLADES. WHEN USING CARBIDE TIPPED BLADES,DO NOT USE BLADES WITH DEEP G

18Fig. 43Fig. 44Fig. 45BRUSH INSPECTIONAND REPLACEMENTBrush life varies. It depends on the load on the motor.Check the brushes after the first 50 hour

19NOTES

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST

3ADDITIONAL SAFETY RULES FORMITER SAWS1. DO NOT OPERATE THIS MACHINE UNTIL it isassembled and installed according to theinstructions.2. OBTAIN ADVICE

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6CARTON CONTENTSRemove the miter saw and all loose items from thecarton. IMPORTANT: CARRYING THE MACHINE BYTHE SWITCH HANDLE WILL CAUSE MISALIGNMENT.

7Fig. 5Fig. 6Fig. 7FASTENING MACHINE TOSUPPORTING SURFACEMOVING CUTTINGHEAD TO THE UP POSITION1. Push down on switch handle (A) Fig. 5 and pull out cu

8OPERATING CONTROLS AND ADJUSTMENTSSTARTING AND STOPPING MACHINETo start the machine, depress switch trigger (A) Fig. 11. To stop the machine, release

ROTATING TABLE FOR MITER CUTTINGYour miter saw will cut any angle from a straight 90 degree cutto 47 degrees right and left. Loosen lock handle (A) Fi