INSTRUCTION MANUALPART NO. A07355 - 09-16-04Copyright © 2004 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DELTA MACHINERY visit our website at
10CFig. 10Fig. 11AADFig. 12ARAISING AND LOWERING HEADASSEMBLYThe head assembly (A) Fig. 12A contains the cutterheadfeed rollers, cutterhead guard and
11LEVELING EXTENSION TABLESThe extension tables (A) and (G) Fig. 14 must be levelwith the planer table. To check the extension tables andadjust if nec
12Fig. 17Fig. 18CARRYING HANDLE/STOCKTRANSFER BAR1. Your planer is provided with a foam covered carryinghandle (A) Fig. 17, located on top of the mach
13Fig. 21Fig. 224. Insert knife transfer tool (G) Fig. 21, underneathcenter of knife. Lift the knife transfer tool up untilknife (H) separates from pi
148. Slide cutterhead guard (B) Fig. 25 in as far aspossible and replace two knobs, one of which is shownat (A) Fig. 25. These knobs were removed in S
15Fig. 27Fig. 28Fig. 29Fig. 31Fig. 30BRUSH INSPECTION ANDREPLACEMENTDISCONNECT MACHINE FROM POWERSOURCE.Brush life varies. It depends on the load on t
16PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Les marquessuivantes sont des
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4GENERAL SAFETY RULES1. FOR YOUR OWN SAFETY, READ THE INSTRUCTIONMANUAL BEFORE OPERATING THE MACHINE.Learning the machine’s application, limitations,
5ADDITIONAL SAFETY RULES FOR PLANERS1. DO NOT OPERATE THIS MACHINE until it iscompletely assembled and installed according tothe instructions. A machi
6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti
7EXTENSION CORDSUse proper extension cords. Make sureyour extension cord is in good condition and is a 3-wireextension cord which has a 3-prong ground
8FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THEENTIRE IN
9Fig. 7Fig. 8Fig. 9CUTTERHEAD GUARD1. Attach the cutterhead guard (A) Fig. 7 to the planerby inserting the end of the guard over the top of thecutterh
Comentários a estes Manuais