Delta DP400 Manual do Utilizador descarregar pdf (Página 10)

Fig. 9

9. Insert table (H) Fig. 9, into hole in table bracket as

shown.

Fig. 10

10. Thread table locking lever (J) Fig. 10, into hole in

front of table bracket as shown.

Fig. 11

Fig. 12

11. Place the drill press head (K) Fig. 11, onto the

column as far as it will go. Align head (K) Fig. 12, with

table (L) Fig. 12, and base (M) Fig. 12, and tighten the

two head locking screws (N) Fig. 11 with the 5mm

wrench supplied.

12. IMPORTANT: Make certain the tapered hole in the

bottom of spindle (T) Fig. 13, and the taper on spindle

adapter (U) are clean and free of any grease, lacquer or

rust preventive coatings. NOTE: If necessary, household

oven cleaner can effectively remove these coatings from

the spindle and spindle adapter; however, carefully follow

the manufacturer’s safety rules regarding its use.

13. Push spindle adapter (U) Fig. 13, up into spindle (T)

making certain the tang (V) engages the mating slot inside

spindle (T).

Fig. 13

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Sem comentários

Delta DP400 Manual do Utilizador Página 10