Delta 50-665 Manual de Instruções descarregar pdf (Página 7)

Fig. 7

Fig. 8

Fig. 9

Fig. 1 1Fig. 10

5. Position the remaining inlet elbow (K) Fig. 8, at the

underside of dust collector lid (C) as shown. Align the

mounting holes in inlet elbows (K) Fig. 8, with screws (J)

assembled to upper inlet elbow (H) shown in Fig. 7,

STEP 4, and fasten the upper and lower inlet elbows to

the cover with remaining two flat washers, lockwashers,

and locknut s (J) Figs. 7 and 8.

6. Place the sheet met al cylinder (L) Fig. 9, onto the

underside of the cover. Align four holes in cylinder brack -

et, three of which are shown at (M), with four holes (N) in

the underside of cover and fasten with four 1/4-20 x 5/8

hex head screws, lockwashers, and locknut s (P) Fig. 10.

NOTE: Assemble screws from the top of the lid down -

ward. CAUTION: Sheet met al cylinder (L) is extremely

sharp; use protective gloves when assembling the sheet

m e t al to the underside of the lid.

7. Assemble safety grid (V) Fig. 1 1, over met al cylinder

(L) and fasten grid to cylinder with three p an head screws

(W) as shown in Fig. 12.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Delta 50-665 Manual de Instruções Página 7