Delta MS210 Manual de Instruções

INSTRUCTION MANUALPART NO. 905590 - 11-26-03Copyright © 2003 Delta MachineryTo learn more about DELTA MACHINERY visit our website at: www.deltamachine

10Fig. 17ADJUSTING BLADE PARALLEL TOTABLE SLOT1. Lower the cutterhead and check to see if the sawblade (A) Fig. 18 is parallel to the left edge (B) of

11Fig. 20CCADJUSTING FENCE 90 DEGREES TO BLADEIf the fence (A) Fig. 19 is removed from the saw, re-adjust it so that it is 90 degrees to the blade whe

12Fig. 24DFig. 24CFig. 24FFig. 24EFig. 23AUXILIARY WOOD FENCEWhen performing multiple or repetitive cut-offoperations that result in small cut-off pie

13Fig. 25Fig. 26Fig. 27Fig. 28CUTTING BOWED MATERIALWhen cutting flat pieces, first check to see if the material is bowed. If it is, make sure the mat

142. When a large number of repetitive cuts of crown moulding are required, we suggest the use of filler blocks, asshown in Fig. 30 through Fig. 33. T

Fig. 39Fig. 40CEFGDUse only cross-cutting saw blades. Use carbide-tipped blades with a negative hook angle. Do notuse blades with deep gullets that ca

16BRUSH INSPECTION AND REPLACEMENTBrush life varies. It depends on the load on the motor.Check the brushes after the first 50 hours of use for anew ma

17PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P

18NOTES

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

3FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. FOR YOUR OWN SAFETY, READ THE INSTRUCTIONMANUAL BEFORE OPERATING THE MACHINE.L

4ADDITIONAL SAFETY RULES FORMITER SAWSRefer to them oftenand use them to instruct others.FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.04

5A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

6EXTENSION CORDSFOREWORDDelta ShopMaster Model MS210 is a 10" Power Miter Saw designed to cut wood, plastic, and aluminum. Cross cuttingand miter

7ROTATING TABLE TO 90 DEGREE POSITION1. Loosen table lock handle (A) Fig. 3 one or two turnsand depress index lever (B) to release 45 degreepositive s

8TABLE HAZARD AREAThe area inside the two red lines (A) Fig. 8 on the table is designated as a hazard zone. Neverplace your hands inside this area whi

9Fig. 12Fig. 13BACBAROTATING TABLE FOR MITER CUTTINGYour miter saw will cut any angle from a straight 90 degree cut to 47 degrees, right and left. Loo