Delta 36-650 Manual de Instruções descarregar pdf (Página 12)

MOTOR PULLEY,

PULLEY GUARD, AND

DRIVE BELT

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Remove the motor shaft key that is taped to the

motor.

2. Insert key (A) Fig. 20, in the keyway on the motor

shaft. Assemble motor pulley (B) on motor shaft as

shown, with the hub of the pulley out. Tighten set screw

3. Slide the belt and pulley guard bracket (G) Fig. 22,

between the motor plate (A) and motor mounting plate

(C), as shown.

5. Position belt and pulley guard bracket (G) Fig. 23, so

the motor pulley (B) is centered and through the hole in

the belt and pulley guard bracket (G), as shown in Fig.

24. Tighten the four hex nuts that fasten the motor to the

motor mounting plate.

6. Using a straight edge, align the motor pulley with the

arbor pulley. If necessary, adjust the motor pulley (B)

Fig. 23, in or out on the motor shaft.

7. Lift up on the motor and assemble the drive belt (H)

Fig. 24, to the arbor pulley and motor pulley (B). The

weight of the motor will provide the correct belt tension.

4. Place a 1/4" external tooth lockwasher onto a 1/4-

20x1-1/2" hex head screw. Insert the screw (D) Fig. 22,

through the hole in the belt and pulley guard bracket (G)

as shown in Fig. 22.

Fig. 20

Fig. 22

Fig. 23

Fig. 24

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sem comentários

Delta 36-650 Manual de Instruções Página 12