Delta 36-655 Manual de Instruções

To learn more about DELTA MACHINERYvisit our website at: www.deltamachinery.com.For Parts, Service, Warranty or other Assistance,please call 1-800-223

10Installing Drive BeltFigure 11Lift up on motor (A) and assemble drive belt ( B) to thearbor pulley (C) and the motor pulley (D). The weight ofthe mo

11Attaching Fence Rails and SlidingExtension TableFigure 15Loosely attach square head screws (4), flat washers (4),and hex nuts (4) to the front edge

12Figure 19Mount sliding extension table (A) into front and rear railchannels (B) using adjustment pads (C). Adjust pads for asmooth but snug fit.Figu

13Figure 23If alignment is necessary, loosen the two screws (A), alignbracket (B) with the arbor flange and tighten screws (A).Loosely assemble large

14Figure 27With the blade guard (A) in the raised position, assemblethe saw blade (B) on the saw arbor using the two bladewrenches.Figure 28This view

15Figure 35Mount switch (A) using hex head screws (2) and squarenuts (2). Install screws with square nuts facing up (B). Donot tighten screws.Figure 3

16Tool Holders and Rail End CapsFigure 39Install front and rear end caps (A) on both ends of fencerails using self tapping screws (4). Install fence h

17Figure 43The miter gage (A) is equipped with a T-slot bar (B).Engage bar at end of miter slot (C) and slide miter gageonto saw table.Figure 44Instal

18The blade can be raised or lowered by unlocking knob (B) and turning the handwheel (C). To raise the blade, turn handwheelclockwise. To lower the bl

19Rip Fence Adjustments DISCONNECT TOOL FROM POWERSOURCE.Figure 49Slide fence (A) against one edge of the miter gage slot (B).L

2GENERAL SAFETY RULES

20Figure 53Release locking handle (A). Push in micro-adjust knob (B)to engage mechanism, then turn handle right or left forprecise settings. Release m

21MAINTENANCEChanging the Saw Blade DISCONNECT TOOL FROM POWERSOURCE.Figure 56Remove table insert (A) and raise saw blade (B) t

22NOTES

NOTES23

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machinepart, or machine accessory which in

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

416. USE RECOMMENDED ACCESSORIES. The use ofaccessories and attachments not recommended by Deltamay cause hazards or risk of injury to persons.17. RED

2. Grounded, cord-connected machines intended for useon a supply circuit having a nominal rating less than 150volts:If the machine is intended for use

6 Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wireextension cord which has a 3-pron

7Figure 5The following saw parts require assembly. Please be sure all of the listed parts are included before starting assembly.Fig. 51. Right Extensi

8Fig. 61. Fence Assembly2. Micro-adjust Assembly with Button HeadScrews (2)3. Front Rail with Square Head Screws (4), FlatWashers (4), Hex Nuts (4), E

9ASSEMBLY INSTRUCTIONS FOR YOUR OWN SAFETY, DO NOTPLUG SAW INTO OUTLET UNTIL THE TOOL ISCOMPLETELY ASSEMBLED AND YOU READ ANDUNDERSTA