Delta MS265 Manual de Instruções descarregar pdf (Página 15)

TYPICAL OPERATIONS AND HELPFUL HINTS

IF THE WORKPIECE CAUSES YOUR

HAND TO BE IN THE HAZARD ZONE

OF OF THE SAW BLADE, CLAMP THE

WORKPIECE IN PLACE BEFORE

MAKING THE CUT.

1. Before cutting, make certain that the cutting arm

and table are at the correct settings and firmly

locked in place.

2. Place the workpiece on the table and hold or clamp

it firmly against the fence (Fig. 31).

3. For best results, cut at a slow, even cutting rate.

4. Never attempt freehand cutting (wood that is not

held firmly against the fence and table).

AUXILIARY WOOD FENCE

Multiple or repetitive cut-off operations that result in

small cut-off pieces (one inch or less) can cause the saw

blade to catch the cut-off pieces and project them out

of the machine or into the blade guard and housing,

possibly causing damage or injury.

TO LIMIT THE POSSIBILITY OF

PERSONAL INJURY OR BLADE

GUARD DAMAGE, MOUNT AN

AUXILIARY WOOD FENCE ON YOUR

SAW.

Holes are provided in the fence to attach an auxiliary fence (A) Fig. 32. This auxiliary fence is constructed of straight

wood approximately 1/2" thick by 3" high by 20" long.

NOTE: The auxiliary fence (A) is used ONLY with the saw blade in the 0° bevel position (90° to the table). When bevel

cutting (blade tilted), remove the auxiliary fence.

Fig. 31

Fig. 32

The tension of the cuttinghead return spring was adjusted

at the factory so that the cuttinghead returns to the “up”

position after a cut has been made. If it becomes neces-

sary to adjust the spring tension:

DISCONNECT MACHINE FROM POWER

SOURCE.

Loosen the locknut (A) Fig. 30 and turn the screw (B)

clockwise to increase, or counterclockwise to decrease

the spring tension. After adjustment, tighten the locknut

(A).

ADJUSTING TENSION OF CUTTINGHEAD RETURN SPRING

Fig. 30

MACHINE USE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Comentários a estes Manuais

Sem comentários

Delta MS265 Manual de Instruções Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Delta MS265