Delta 40 Manual de Instruções

INSTRUCTION MANUAL16" Scroll Saw(Model 40-530)PART NO. 900621 (011)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 15To learn more about DELTA MA

10TILTING THE TABLEThe table (A) Fig. 20, on your scroll saw can be tilted upto 45 degrees to the left for bevel cutting operations.1. Turn the table

11ADJUSTINGHOLDDOWNThe bottom of the holddown (A) Fig. 24, should beadjusted so it contacts the top surface of the work beingcut by loosening lock han

12LUBRICATIONUse the maintenance procedure listed below after each20 hours (approximate) of use.1. MAKE CERTAIN THE MACHINE IS DISCONNECT-ED FROM THE

13NOTES

Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessorywhich in normal use has proven to

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

ADDITIONAL SAFETY RULES FORSCROLL SAWS319. DO NOT feed the material too fast while cutting.Only feed the material fast enough so that the blade willcu

4CONNECTING TOOL TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12

Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extensioncord which has a 3-prong grounding type plug an

6ASSEMBLY INSTRUCTIONSWARNING: THE USE OF ACCESSORIES OR AT-TACHMENTS NOT RECOMMENDED BY DELTA MAYRESULT IN RISK OF INJURY.WARNING: TO AVOID INJURY FR

76. Re-attach blade to upper blade holder. (See thesection “CHANGING BLADES”, begin with instruction#6).7. Assemble table insert (C) Fig. 9, to table

8WRENCH AND BLADESTORAGEA convenient wrench and blade holder (A) Fig. 13, issupplied on the left side of the rear casting, which allowsyou to store t

96. Insert long end (A) Fig. 16, of quickset bladechanging wrench into hole (G) in lower blade holder. Thiswill automatically align wrench (C) with bl