Delta 22-540 Manual do Utilizador descarregar pdf (Página 7)

ASSEMBLY INSTRUCTIONS

Fig. 4

Fig. 5

Fig. 6

ASSEMBLING RAISING AND

LOWERING HANDLE

1. Assemble raising and lowering handle (A) Fig. 4, to

shaft (B) and fasten in place with screw (C). NOTE: Make

certain the flats of the handle and flat on shaft are

aligned with each other.

2. Flip handle (A) upward as shown in Fig. 5.

LOWERING

EXTENSION TABLES

The infeed and outfeed extension tables (A) Fig. 6, are

shipped attached to the machine in the raised position.

Lower the tables (A) on both sides of the planer

as shown in Fig. 6. The top surface of extension tables

should be level with the planer table. To check and

adjust if necessary, refer to section “LEVELING

EXTENSION TABLES” of this manual.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Sem comentários

Delta 22-540 Manual do Utilizador Página 7