Delta TP300 Manual do Utilizador

INSTRUCTION MANUAL12" Portable Planer(Model TP300)PART NO. 909543 - 05-01-03Copyright © 2003 Delta MachineryTo learn more about DELTA MACHINERY v

10OPERATING CONTROLS AND ADJUSTMENTSFig. 13Fig. 14Fig. 15Fig. 16STARTING ANDSTOPPING PLANERThe “ON/OFF” switch (A) Fig. 13, is located on the frontof

11Fig. 17Fig. 18Fig. 19Fig. 20LEVELINGEXTENSION TABLESFor optimum performance, the extension tables, one ofwhich is shown at (A) Fig. 17, must be leve

124. If an adjustment to one or both knives is necessary, slightly loosen the seven locking screws, six of which areshown at (C) Fig. 21, by turning t

13Fig. 23LIFTING STRAPSYour planer is provided with two lifting straps (A) Fig. 23,located on the top of the planer, for ease in transportingthe plane

14MAINTENANCEFig. 26Fig. 27Fig. 28Fig. 30Fig. 29BRUSH INSPECTIONAND REPLACEMENTDISCONNECT MACHINE FROM POWERSOURCE.Brush life varies. It depends on th

15NOTES

16PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

3FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. FOR YOUR OWN SAFETY, READ THEINSTRUCTION MANUAL BEFORE OPERATING THEMACHINE. L

4ADDITIONAL SAFETY RULES FOR PLANERSFAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURYSAVE THESE INSTRUCTIONS. Refer to them often an

5A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

6Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wireextension cord which has a 3-prong grounding type plug

7PLANER PARTS1 - 12" Planer2 - Chip DeflectorFig. 2Fig. 33 - Knife Setting Gage4 - 8mm and 10mmOpen-End Wrench5 - M5 x 20mm HexSocket Head Screw6

8ASSEMBLYFig. 4Fig. 5Fig. 6RAISING AND LOWERINGHANDLE1. Assemble raising and lowering handle (A) Fig. 4, toshaft (B) and fasten in place with M5x20mm

9Fig. 7Fig. 8Fig. 9CHIP DEFLECTOR1. Assemble chip deflector (A) Fig. 7, to the planer byinserting end of chip deflector over the top of thecutterhead.