Delta SA150 Manual de Instruções

INSTRUCTION MANUAL1" Belt / 5" DiscSander(Model SA150)PART NO. 905593 - 05-31-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 13To learn m

10Fig. 26Fig. 23Fig. 24Fig. 25CHANGING ABRASIVE BELT1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove lock knob (A) Fig. 23, and remove sidecover (B).

11Fig. 27Fig. 28MITER GAGEA miter gauge (A) Fig. 27, is supplied with your sanderand can be used on the disc table. The miter gauge head(A) can be set

12Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORBELT / DISC SANDERSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.SAVE THESE INSTRUCTIONS. R

4Fig. A Fig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDINGMEANSADAPTERPOWER CONNECTIO

Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug an

6BELT SANDER TABLE1. DISCONNECT MACHINE FROM POWER SOURCE.2. Locate the M8x1.25x30mm hex head screw (A) Fig.2, M8.4 flat washer (B), and table locking

7ABRASIVE TO SANDINGDISC1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove one-half of the abrasive backing (A) Fig. 7,to expose the adhesive.3. Attach

8Fig. 15Fig. 16Fig. 17OPERATING CONTROLS AND ADJUSTMENTSSTARTING ANDSTOPPING SANDERThe switch (A) Fig. 15 is located on the top of the switchbox. To s

9Fig. 22Fig. 21Fig. 20Fig. 19The disc table (C) can be tilted down 45 degrees (Fig.21), by loosening the two wing nuts (one of which isshown at (B) Fi